CHAPTER 7 SYSTEM SETUP
29
Delay Switch When alarm is issued in the primary line, the configured time is the waiting
time to activate the switching protection (switch from the primary line to the
backup line).
Recover Delay It’s the delay switch for the backup line to switch back to the Master one
when the Master line recovers from link failure.
After you key in the active bundle time, press ESC. A prompt will ask if you wish to change the
configuration. Press Y to confirm.
>> Change configuration (Y/N)? (Note:to save,please use V-command)
When the configuration is successfully changed, the screen will return to the previous menu.
7.2.2. Qos Setup
¾ Command Path
Main Menu > (S) System Setup > (C) Qos Setup
¾ Description
There are three options you can select from the Qos Setup: (A)
Class of Service (B) Transmission Scheduling (C) Rate
Control.
NOTE: Please refer to the Chapter 8 Appendix A: Quality of Service Setup for the entire explanation
and setup procedure on QoS Setup.
7.2.2.1. Class of Service
¾ Command Path
Main Menu > (S) System Setup > (C) Qos Setup > (A) Class of
Service
¾ Description
There are four options you can select from the Class of
Service: (A) Priority Mode Setup (B) Fixed Priority Setup (C)
Vlan CoS Priority Setup (D) ToS Field Priority Setup.
7.2.2.1.1. Priority Mode Setup
¾ Command Path
Main Menu > (S) System Setup > (C) Qos Setup > (A) Class of
Service > (A) Priority Mode Setup
¾ Function
Enables users to change the priority mode for each port
Table 7-3 Priority Mode Setup
Field Setting Options Default
ETH1~4 Fixed, CoS, ToS Fixed
¾ Priority Mode Setup Screen:
Using Tab to select one of the options for each port:
SLOT 2 TDMoE === Priority Mode Setup === 10:40:53 12/31/2009
ARROW KEYS: CURSOR MOVE, TAB: ROLL OPTIONS
ETH1: Fixed
ETH2: Fixed
ETH3: Fixed
ETH4: Fixed
<< Press ESC key to return to previous menu >>
After you change the priority mode for ETH1, ETH2, ETH3, and ETH4, press Esc. A prompt will ask if
you wish to change configuration. Press Y to confirm.
Change configuration (Y/N)? (Note:to save,please use V-command)
To Next Page
Loading...