Loop Telecom AM3440 series User Manual

CHAPTER 7 SYSTEM SETUP
36
Electrical
[ETH1]
Port Status : Enable
Auto Negotiation: Enable
Speed : 10Mbps
Duplex : Half
<< Press ESC key to return to previous menu >>
NOTE: If Auto Negotiation is Enable, then there is no need to setup Speed and Duplex. If both local
and remote devices configure Auto Negotiation as Disable, then configurations of Speed and
Duplex for both devices should be the same. Otherwise, the link will fail. If Auto Negotiation is
Disable for the local device and is Enable for the remote device, then the remote device needs
not configure Speed and Duplex. It will automatically apply same configurations of the two
modes as those of the local device.
After you change the setting options for each field, press ESC. A prompt will ask if you wish to change
configuration. Press Y to confirm.
Change configuration (Y/N)? (Note:to save,please use V-command)
When the configuration is successfully changed, the screen will return to the previous menu.
7.2.4. Ethernet Switch Setup
¾ Command Path
Main Menu > (S) System Setup > (L) Ethernet Switch Setup
¾ Function
Here, you can setup the age time for Ethernet layer two ports,
and add or delete any Ethernet port and its MAC address.
¾ Description
For setup procedures, please see the screen demonstrations
shown below.
Age Time: the period of time that MAC addresses are flushed
from the MAC Address Table if they have not been
accessed during that interval
MGT: Management
Table 7-13 Ethernet Switch Setup
Field Setting Options Default
Age Time 1~3825 0000300
Table 7-14 Add Ethernet MAC Address
Field Setting Options Default
Add port MGT, ETH1, ETH2, ETH3, ETH4 MGT
Add MAC Setup by user 00 00 00 00 00 00
Table 7-15 Delete Ethernet MAC Table
Field Setting Options Default
Delete port MGT, ETH1, ETH2, ETH3, ETH4 MGT
Delete MAC Yes, No No
¾ Ethernet Switch Setup Screens:
When you enter this section, you will first see the Ethernet Switch Setup menu. Use arrow keys to
select the action you need.
SLOT 2 TDMoE === Ethernet Switch Setup === 15:28:32 12/31/2009
Select Action >> *Age MAC Address
If you select Age, you will see a screen as below:
SLOT 2 TDMoE === Ethernet Switch Setup === 15:35:17 12/31/2009
ARROW KEYS: CURSOR MOVE, Please input: 0~1048575, BACKSPACE to edit

Loop Telecom AM3440 series Specifications

General

Brand	Loop Telecom
Model	AM3440 series
Category	Network Router
Language	English