Need help?Do you have a question about the Loop Telecom IP6610 and is the answer not in the manual?
General| Wireless | No |
|---|---|
| VPN Support | Yes |
| Firewall | Yes |
| QoS | Yes |
| Uplink | 4 x GE (2 x SFP) |
| WAN Ports | 4 x GE (2 x SFP) |
Provides a detailed overview of the Loop-IP6610 router's features, connectivity, and capabilities.
Lists detailed technical specifications for the E1, DS1, DTE, DCE, and physical interfaces.
Provides admin commands for configuring WAN1 interfaces, including E1 and DS1 parameters.
Details admin commands for setting up the LAN1 interface, including IP address, routing, and speed.
Lists DHCP admin commands for configuring network, IP range, leases, and server state.
Provides a step-by-step guide for setting up the DHCP server, including subnet, domain, and DNS configuration.
Details admin commands for configuring Frame Relay layer 2 protocols, PVCs, and routing.
Guides users through setting up Frame Relay layer 2 protocols, PVCs, IP addresses, and routing.
Lists admin commands for setting LAN/WAN routing protocols, NAT, and static routes.
Provides step-by-step configuration for IP routing, including LAN IP, WAN protocol, and routing protocols.
Details admin commands for NAT setup, including enabling NAT/NAPT and specifying interfaces.
Guides users through enabling NAT, setting LAN IP, WAN protocol, and adding routes for network address translation.
Lists admin commands for adding, deleting, and setting up packet filtering rules based on various criteria.
Provides step-by-step instructions for configuring packet filtering rules, including permit and deny actions.
Details admin commands for adding/deleting port forwarding entries and managing NAT settings.
Guides users through setting NAT mode and configuring port forwarding for HTTP and FTP services.
Lists admin commands for setting bridge IP, gateway, CRC, MAC aging, and interfaces.
Guides users through configuring units for remote bridge mode, including layer 2 protocol and CRC settings.
Lists admin commands for SNMP configuration, including community, contact, location, device name, and trap addresses.
Provides step-by-step instructions for configuring SNMP settings such as community, contact, location, and device name.
Lists STP/RSTP admin commands for configuring spanning tree parameters like version, state, priority, and port settings.
Guides users through configuring STP/RSTP settings, including bridge priority, port priority, age, delay, and link types.
Details VLAN commands for creating, managing, and configuring VLAN features and port settings.
Details commands for configuring VLAN stacking features, including SVLAN creation and port assignment.
To Next Page
