Loop Telecom IP6610 User Manual

Chapter 20 Setting Up Firmware/Configuration Up/Download with TFTP Server
91
20 Setting Up Firmware/Configuration Up/Download with TFTP Server
20.1 Overview
Firmware/Configuration Up/Download functions can be performed with the server on the LAN side (ie. same
location as the IP 6610) or with the TFTP server on an outside network.
20.1.1 Upload/Download With The TFTP Server on The LAN Side.
Figure 20-1, below illustrates the Loop-IP 6610 being used in Router mode. The TFTP Server is on the LAN
side. The IP addresses and gateway addresses used in the diagram correspond to the step by step
configuration instructions found in Section 20.1.2 below.
TFTP
Server
VT-100 Monitor
IP:
100.1.1.1
Note: Both the Loop-IP
6610
and the TFTP
Server
are at the same
location
DB9 to PC's COM
port. Newer laptop PCs
will require a DB9 to
USB cable.)
Local
Network
Ethernet Port
Console Port
Loop-IP 6610
IP: 100.1.254.254
Gateway: 255.255.0.0
Figure 20-1 Firmware/Configuration Up/Download with TFTP Server on LAN Side
Note: In this application the Loop-IP6610 and the TFTP Server are at the same location. Connect a
cable between the Com port of your PC and the Console port of the IP6610.

Loop Telecom IP6610 Specifications

General

Brand	Loop Telecom
Model	IP6610
Category	Network Router
Language	English