Loop Telecom IP6610 - 5.4 LAN1 Setup

Chapter 5 Loop-IP6610 Setup
26
WAN1 Admin Commands – DS1
Parameters Description
yel
Setting on/off enable/disable DS1 YEL
inband
Setting on/off enable/disable DS1 inband loopback
code
address
Setting csu,te set DS1 address
primary_clk
Clock source line/internal set DS1 primary clk source
secondary_clk
Clock source line/internal set DS1 secondary clk source
timer
Timing 0~86400 set DS1 diagnostic function timer
timeslot wan_intf
wan1
start TS
1-24
[endTS]
1-24
add
Add timeslot wan1 1-16
add one or more DS1 timeslots to wan1
net address
timeslot wan_intf
wan1
start TS
1-24
[endTS]
1-24
remove one or more timeslots from wan1
performance
Delete DS1 performance data
bert
release DS1 bert
delete
loopback
release an DS1 loopback
type
clock-loss LOS, LOF, AIS,
YEL, BPB, ES, UAS, CSS
setting
enable/
disable
enable/disable
reporting of a specific alarm
type threshold
value
BPV,ES,UAS
59
set alarm
CSS
1900
set specific alarm’s reporting threshold
5.4 LAN1 Setup
To setup LAN1 use the admin commands in Table 5-4 below.
Table 5-4 LAN1 Admin Commands
LAN1 Admin Commands
Parameters Description
ip ip_addr
xxx.xxx.xxx.xxx
subnet_mask
xxx.xxx.xxx.xxx
Set LAN1 IP address
routing protocol
rip1/rip2/static
Set Layer 3 routing protocol
set lan1
speed 10/100/auto LAN1 speed/duplex setting
only for IP6610 with one LAN
port
Note: The speed setting for IP6610 with four LAN ports is always AUTO.