Loop Telecom IP6610 User Manual

Chapter 24 APPENDIX D – Application Note
166
12. set dte mode async
13. set async 115200 8 none 1
14. add nat static 0.0.0.0 10.4.5.10
Note:
1. Step 1 to 4 are WAN1 Modem setup, refer to Chapter 14 Model Dial Up for detail.
2. Both USERNAME and PASSWORD can be set up to 31 characters.
3. The IP6100 will be triggered to send AT command to modem while the LAN port receives the packet.
Condition 2:
When the ATM machine has dynamic IP address, you need to enable IP6610 DHCP function to get an IP
address. The application illustration shows below.
Figure 24-3 Mobil ATM Application with Dynamic IP
CLI Setup
The following is the step by step CLI configuration for above application.
1. set wan1 modem init AT+CRM=1
2. set wan1 modem phone #777
3. set wan1 modem timeout 0
4. set lan1 ip 10.10.10.1 255.255.255.0

Loop Telecom IP6610 Specifications

General

Brand	Loop Telecom
Model	IP6610
Category	Network Router
Language	English