Loop Telecom IP6610 - Table 21-5 DCE Command Lines

Chapter 21 Appendix A: Operation Commands
115
Table 21-5 DCE Command Lines
DTE Command Lines
Command Parameters Description Br.
Rt.
Level
intf1
lan1/wan1
Create one of the media forwarding set. (lan1/wan1)
add
media_forward
intf2
lan1/wan1
Create two of the media forwarding set. (lan1/wan1)
V
V
Admin
intf1
lan1/wan1
Delete one of the media forwarding set. (lan1/wan1)
delete
media_forward
intf2
lan1/wan1
Delete two of the media forwarding set. (lan1/wan1)
V
V
Admin
type
dcd(data Carrier Detect), cts(Clear to Send), dsr(Data Set
Ready), ttm, rts(Request to Send), dtr(Data Terminal
Ready), tx_clock, rx_clock, tx_data, and rx_data
Signal name for the setting
set DCE
Setting
On/Off
normal/inverted
For control signals
(dcd/cts/dsr/ttm/rts/dtr):
“on” forces the interface to assert the signal
or follow the control signal.
“off” de-asserts the signal or ignores the
control signal.
For signal polarity
(tx_clock/rx_clock/tx_data/rx_data):
“normal” instructs the interface to use normal
polarity.
“inverted” instructs the interface to use
inverted polarity
V
V
Admin
Status
Show DCE Status V
V
OP
DCE
Setup
Show DCE Setup V
V
OP
show
media_forward media_forward
Show media forwarding settings V
V
OP