Chapter 21 Appendix A: Operation Commands
153
which counts all single error. User may use key to inject single bit error, key to reset
error counter, and ESC key to quit PRBS test display.
Parameters: none
Command: >show e1 line availability
Syntax: show e1 line availability
Explanation: Shows E1 line availability during the last 24-hour period. The information, based on the
user performance register set, includes the valid seconds, available seconds, unavailable
seconds and line availability.
Parameters: none
Command: >show e1 line setup
Syntax: show e1 line setup
Explanation: Displays the system E1 setup.
Parameters: none
Command: >show e1 line status
Syntax: show e1 line status
Explanation: displays the system E1 status
Parameters: none
Command: >show e1 performance
Syntax: show e1 performance type period
Explanation: To view line receiver performance status report
Parameters: type line/user
Period 1hr/24hr
[Performance] es/uas/bes/ses/css/as/efs/bpv (for 24hr period)
Command: >show e1 statistics
Syntax: show e1 statistics type period
Explanation: To view line receiver performance status statistics report
Parameters: type line/user
Period 1hr/24hr
[Performance] es/uas/bes/ses/css/as/efs/bpv (for 24hr period)
21.2.15 DS1 Commands
Command: >activate DS1 loopback
Syntax: activate DS1 loopback loopback_type
Explanation: Activate loopback function.
Parameters: loopback_type line/payload
Command: >activate DS1 remote_loopback
Syntax: activate DS1 remote_loopback remote_loopback_activate_code_type
Explanation: Send remote loopback active code to far end.
Parameters: remote_loopback_activate_code_type in-band/at&t-payload/ansi-payload/ansi-line
Parameters: loopback_type
To Next Page
Loading...
