Chapter 8 IP Routing Setup
39
8.3 Step by Step Setup Instructions
Connect a cable between the COM port of your PC and the Console port of the IP 6610. Then follow the
instructions below.
Double-click the LoopTerm icon on your PC’s desktop screen. The following screen will appear. Then
double–click on the icon in the figure below (see arrow)..
A blank screen with a flashing cursor will appear. Key in the command login admin.
Then press the Enter key.
Note: It is possible that the IP-6610 is presently in Bridge mode rather than Router mode. If you are
unsure, key in the admin command delete bridge. Then press the Enter key. If the IP-6610 is in
Bridge mode it will switch to Router mode.
Set the LAN1 IP and MASK addresses. Key in the admin command set lan 1 ip followed by the LAN1 IP
address and MASK address. Then press the Enter key. In the sample screen below we keyed in set lan ip
192.168.1.1 255.255.255.0 and then pressed the Enter key.
To Next Page
Loading...
