Loop Telecom IP6610 User Manual

Chapter 21 Appendix A: Operation Commands
159
21.2.17 DCE Commands
Command: add media_forward
Privilege: admin
Syntax: add media_forward intf1 intf2
Explanation:
Create a media forward set
Parameters:
intf1 Interface one of the media forwarding set. (lan1/wan1)
intf2 Interface two of the media forwarding set. (lan1/wan1)
Command: delete media_forward
Privilege: admin
Syntax: delete media_forward intf1 intf2
Explanation:
Delete a media forward set
Parameters:
intf1 Interface one of the media forwarding set. (lan1/wan1)
intf2 Interface two of the media forwarding set. (lan1/wan1)
Command: set dce
Privilege: admin
Syntax: set dce type setting
Explanation:
Show DCE interface settings
Parameters:
type Signal name for the setting. Valid names are dcd, cts. dsr, ttm, rts,
dtr, tx_clock, rx_clock, tx_data, and rx_data.
setting For control signals (dcd/cts/dsr/ttm/rts/dtr):
“on” forces the interface to assert the signal or follow the
control signal.
“off” de-asserts the signal or ignores the control signal.
For signal polarity (tx_clock/rx_clock/tx_data/rx_data):
“normal” instructs the interface to use normal polarity.
“inverted” instructs the interface to use inverted polarity.
Command: show dce setup
Privilege: operator
Syntax:
show dce setup
Explanation:
Show DCE interface settings
Parameters:
None
Command: show dce status
Privilege: operator
Syntax:
show dce status
Explanation:
Show DCE interface status
Parameters:
None
Command: show media_forward
Privilege: operator
Syntax:
show media_forward
Explanation:
Display media forwarding settings
Parameters:
None

Loop Telecom IP6610 Specifications

General

Brand	Loop Telecom
Model	IP6610
Category	Network Router
Language	English