Loop Telecom IP6610 User Manual

Chapter 6 DHCP Server Setup
29
6.3 Step by Step Setup Instructions
Connect a cable between the COM port of your PC and the Console port of the IP 6610. Then follow the
instructions below.
Double-click the LoopTerm icon on your PC’s desktop screen. The following screen will appear. Then
double–click on the icon in the figure below (see arrow).
A blank screen with a flashing cursor will appear. You must add a subnet. Key in the command add dhcp
subnet plus the subnet you wish to declare. In our example we declared the subnet loop1. Press the Enter
key.
You must enter a dhcp server address for the subnet. Key in the command set dhcp server subnet
network loop1 followed by the IP address and subnet mask of the loop device. The IP address and subnet
mask entry we used was: 192.168.1.0 255.255.255.0. Press the Enter key.
You must establish a subnet range. Key in the command set dhcp server subnet ip_range loop1
followed by the starting IP address and the ending IP address in the range. The addresses we used to
establish the range were:192.168.1.5 and 192.168.1.20.

Loop Telecom IP6610 Specifications

General

Brand	Loop Telecom
Model	IP6610
Category	Network Router
Language	English