Loop Telecom IP6610 User Manual

Chapter 21 Appendix A: Operation Commands
145
Command: >set wan1 pvc ip
Syntax: set wan1 pvc ip pvc_no ip_addr net_mask
Explanation: Sets IP address for PVC of WAN1.
Parameters: pvc_no PVC number. The possible value is 1 to 10
ip_addr IP address of the WAN port
net_mask subnet mask of the WAN port
Command: >set wan1 pvc routing
Syntax: set wan1 pvc routing pvc_no protocol
Explanation: Sets routing protocol for PVC of WAN1.
Parameters: pvc_no PVC number. The possible value is 1 to 10
protocol rip1 – enable RIP1 routing protocol for WAN1
rip2 – enable RIP2 routing protocol for WAN1
static – turn off all dynamic routing protocols and enables static routing
Command: >set wan1 routing
Syntax: set wan1 routing protocol
Explanation: Sets routing protocol of WAN1.
Parameters: protocol rip1 – enable RIP1 routing protocol for WAN1
rip2 – enable RIP2 routing protocol for WAN1
static – turn off all dynamic routing protocols and enables static routing
Command: >set media_forward
Syntax: add media_forward intf1 intf2
Explanation: Create a media forward set
Parameters: protocol rip1 – enable RIP1 routing protocol for WAN1
rip2 – enable RIP2 routing protocol for WAN1
static – turn off all dynamic routing protocols and enables static routing
Command: add media_forward
Privilege: admin
Syntax: add media_forward intf1 intf2
Explanation:
Create a media forward set
Parameters:
intf1 Interface one of the media forwarding set. (lan1/wan1)
intf2 Interface two of the media forwarding set. (lan1/wan1)
21.2.11 Show Commands
Command: >show alarm
Syntax: show alarm
Explanation: Show current alarm status
Parameters: None
Command: >show bridge
Syntax: show bridge
Explanation: Show bridge information including the following:
interfaces in bridge mode

Loop Telecom IP6610 Specifications

General

Brand	Loop Telecom
Model	IP6610
Category	Network Router
Language	English