Loop Telecom IP6610 User Manual

Chapter 8 IP Routing Setup
38
8 IP Routing Setup
8.1 Overview
Figure 8-1 below illustrates the Loop-IP 6610 being used in Router mode. The IP addresses and gateway
addresses used in the diagram correspond to the sample step by step configuration instructions in Section
8.3
E1 1 2 3 4
IP Network
IP Router
IP: 160.2.254.253
Gateway: 255.255.0.0
Network Address
100.3.0.0
255.255.0.0
Local Network
with Public IP
Address
Loop-IP 6610
LAN 1 with Public IP Address
IP: 192.168.1.1
MASK: 255.255.255.0
E1
(PPP or HDLC)
WAN 1 with Public IP Address
IP: 100.2.254.254
MASK: 255.255.0.0
Peer Router
IP 100.2.254.253
Figure 8-1 IP Routing Setup
8.2 Routing Admin Commands
To set up the Router function you will use the commands in Table 8-1 below. Step by step instructions
follow the table.
Table 8-1 Routing Admin Commands
Routing Admin Commands
Commands Parameters Description
lan1/wan1
routing
rip1, rip2, static
Set LAN1/WAN1 routing protocol. “Static” disables all
routing protocols.
wan1
pvc
pvc_no
1-10
routing
rip1, rip2, static
Set PVC routing protocol. “Static” disables all routing
protocols. This command is available when the layer 2
protocol of WAN1 is set to Frame Relay.
set
nat
Setting nat,napt, off Enable/disable NAT function type
add
route Add static route
delete route Delete static route

Loop Telecom IP6610 Specifications

General

Brand	Loop Telecom
Model	IP6610
Category	Network Router
Language	English