Loop Telecom IP6610 - DHCP Relay Step by Step Setup

Chapter 6 DHCP Server Setup
33
6.4.1 DHCP Relay Step by Step Setup
After setting up your DHCP server, key in the command set dhcp relay server, followed by the IP address
of the Loop-IP 6610 unit that you will use as a relay server. Press Enter. The IP-6610 ip address we used
was 10.3.2.10.
A will advise you that the command succeeded. You must now activate the relay server. Key in the
command set dhcp relay state on and press Enter. When a prompt advises you that the command
succeeded the setup procedure will be complete.