Loop Telecom IP6610 - Ethernet Connection; Line Connections; Table 2-2 RJ45 10;100 M Ethernet Connector Pin Assignment; Table 2-3 E1;RJ48 Connector Pin Assignment

Chapter 2 Loop-IP6610 Installation
6
2.5.2 Ethernet Connection
RJ45 10/100M Ethernet connection pin assignments are listed in Table 2-2 below.
Table 2-2 RJ45 10/100M Ethernet Connector Pin Assignment
Pin Number Signal Signal Direction
1 Transmit Data + Output from IP 6610
2 Transmit Data - Output from IP 6610
3 Receive Data + Input to IP 6610
4 No Connection
5 No Connection
6 Receive Data - Input to IP 6610
7 No Connection
8 No Connection
Note: The Ethernet interface supports Auto MDI/MDI-X and will work with either a parallel or a crossover
cable.
2.5.3 Line Connections
Line connections are either via BNC( E1) connectors or RJ48 (E1/DS1) connectors. E1 and DS1 pin
assignments for the RJ48 connector are listed in Tables 2-3 and 2-4, below.
Table 2-3 E1/RJ48 Connector Pin Assignment
Pin Number Signal Signal Direction
1 Receive Ring From E1 Network
2 Receive Tip From E1 Network
3 Unassigned
4 Transmit Ring To E1 Network
5 Transmit Tip To E1 Network
6 Unassigned
7 Shield Ground
8 Shield Ground
Table 2-4 DS1/RJ48 Connector Pin Assignment
Pin Number Signal Signal Direction
1 Receive Ring From DS1 Network*
2 Receive Tip From DS1 Network*
3 Unassigned
4 Transmit Ring To DS1 Network*
5 Transmit Tip To DS1 Network*
6 Unassigned
7 Shield Ground
8 Shield Ground