Chapter 20 Setting Up Firmware/Configuration Up/Download with TFTP Server
94
20.2 Step by Step Setup Instructions
Double-click the LoopTerm icon on your PC’s desktop screen. The following screen will appear. Then
double–click on the icon in the figure below (see arrow).
A blank screen with a flashing cursor will appear. Key in the command login admin.
Then press the Enter key.
To upload configuration proceed to section: Configuration Upload.
To download configuration proceed to section: Configuration Download.
To download firmware proceeds to section: Firmware Download.
20.2.1 Configuration Upload
Key in the admin command upload configuration followed by the IP address and the file name of the
TFTP Server. Example below: admin>upload configuration 100.1.1.1 run, 100.1.1.1 is IP address
and run is the file name. Then press Enter. Your screen will tell you how many bytes were transmitted
and if the upload was successful.
To Next Page
Loading...