Loop Telecom IP6610 User Manual

Chapter 21 Appendix A: Operation Commands
157
Command: >set alarm type
Syntax: set alarm type setting
Explanation: Enable or disable a alarm type.
Parameters: type clock_loss/yel/ais/los/lof/bpv/es/uas/css/
etherneDS1/ethernet2/ethernet3/ethernet4/
all (use all to select all alarm)
setting Enable/disable
Command: >set alarm BPV/ES/UAS/CSS threshold
Syntax: set alarm BPV/ES/UAS/CSS threshold value
Explanation: Set alarm threshold.
Parameters: value
21.2.17 DTE Commands
Command: >set alarm
Syntax: set alarm type setting
Explanation: Enable or disable a alarm type
Parameters: etherneDS1/ethernet2/ethernet3/ethernet4
/dcd/cts/dtr/all
Command: >set dte
Syntax: set dte setting
Explanation: to set dte singal
Parameters:
type 1 Signal(dcd/cts/dsr/rts/dtr/LL/RL)
setting 1 (on/off)
type 2 (tx_clock/rx_clock/tx_data/rx_data)
setting 2 (normal/inverted)
Note x21 card support (dcd/rts) only
Command: >show dte status
Syntax: display the system dte status
Explanation: show dte current status.
Parameters:
RCV DCD = LOSS
RCV TM = OFF
RCV DSR = LOSS
RCV CTS = LOSS
XMT DTR = ACTIVE
XMT RTS = ACTIVE
Command: >show dte setup
Syntax: display the system dte setup
Explanation: show dte current setup
Parameters:
DCD = OFF
CTS = ON

Loop Telecom IP6610 Specifications

General

Brand	Loop Telecom
Model	IP6610
Category	Network Router
Language	English