Loop Telecom IP6610 - Page 181

Chapter 21 Appendix A: Operation Commands
158
DSR = ON
RTS = ON
DTR = ON
TX CLOCK = NORMAL
RX CLOCK = NORMAL
TX DATA = NORMAL
RX DATA = NORMAL
LL = OFF
RL = OFF
Command: >show alarm
Syntax: show alarm
Explanation: Show current alarm status
Parameters:
etherneDS1 DIS ALM 0
ethernet2 DIS OK 0
ethernet3 DIS ALM 0
ethernet4 DIS ALM 0
DCD_loss EN ALM 0
CTS_loss DIS ALM 0
DSR_loss DIS ALM 0
Command: >show dte diagnostic
Syntax: show dte diagnostic
Explanation: The dte-to-dte loop is off
Parameters: none
Command: >activate dte loop dte-to-dte
Syntax: activate dte loop dte-to-dte
Explanation: Activate dte loop dte-to-dte
Parameters: none
Command: >release loop
Syntax: release loop
Explanation: release loop
Parameters: none