Chapter 7 Frame Relay Setup
37
bandwidth. Physical bandwidth can be calculated by using the formula Physical bandwidth= n (#
of
timeslots mapped) x 64k. If you are unsure as to how many timeslots you used in your WAN1
mapping, you can check by using the command show time_slot.
You must establish a PVC IP address. Key in the command set wan1 pvc ip 1 followede by the PVC IP
address and subnet mask. The address entry we used was: 100.2.254.254 255.255.0.0. Press the Enter
key.
You must establish a PVC routing protocol. Key in the command set wan pvc routing 1 followed by the
parameter you require. In our sample screen we chose to use rip2 as our parameter. Press the Enter key.
This setup procedure is now complete.
To Next Page
Loading...
