Loop Telecom IP6610 User Manual

Chapter 21 Appendix A: Operation Commands
146
management ip address
gateway address
mac ageing interval
CRC check feature on or off
Parameters: None
Command: >show config
Privilege:
Operator
Syntax: show system config [file]
Explanation:
Show the system configuration
Parameters: [file] working_cfg/startup (default is working_cfg)
Command >show dhcp status
Syntax: show dhcp status
Explanation: Display current DHCP running status
Parameters: None
Command: >show dhcp lease
Syntax: show dhcp lease
Explanation: Show all offered leases to the clients including dynamic BOOTP and abandoned leases.
This does not include fixed leases (i.e. if some hosts have fixed leases those will not be
displayed here.)
Parameters: None
Command: >show dhcp config all
Syntax: show dhcp config all
Explanation: Show whole dhcp configurations including global, Show whole dhcp subnets and hosts.
Parameters: None
Command: >show dhcp config global
Syntax: show dhcp config global
Explanation: Show the global configuration only , not part of any subnet or host.
Parameters: None
Command: >show dhcp config subnet
Syntax: show dhcp config subnet name
Explanation: Show configuration only for the specific subnet identified by the name
Parameters: name
Command: >show dhcp config host
Syntax: show dhcpconfig host name
Explanation: Show configuration only for the specific host identified by the name.
Parameters: name
Command: >show filter
Syntax: show filter [list_name]
Explanation: shows packet filtering rules
Parameters: list_name if you want a particular filter list to show, input the name of the list here.

Loop Telecom IP6610 Specifications

General

Brand	Loop Telecom
Model	IP6610
Category	Network Router
Language	English