Loop Telecom IP6610 User Manual

Chapter 19 Modem Dial-Up
90
Step 5. The command show wan1 modem can show the modem configuration.
admin>show wan1 modem
Modem configuration for wan1
=======================================
Initialize at_cmd: AT&F1
Dial status: enable
Phone number: 1111
Timeout: 20
State: connect 28800 bps
command succeeded
The setup procedure is now complete.
Here are the definitions for the modem state:
idle The phone line is idle.
init The IP6610 is sending initial AT commands to the MODEM and waiting for response from the
MODEM.
dial The Modem is dialing a number and waiting for establish of a call.
connect A call is already established. The number following string “connect” is connection speed between the
two Modems.
hang The IP6610 is hanging up a call.

Loop Telecom IP6610 Specifications

General

Brand	Loop Telecom
Model	IP6610
Category	Network Router
Language	English