To Next Page

To Previous Page

MERLIN LEGEND Communications System Release 6.1

System Programming Guide

555-661-111

Issue 1

August 1998

Programming with SPM

Page 2-2System Requirements

This book describes the use of SPM on a PC with a DOS operating system only. If

you are using Win SPM, refer to the documentation that was provided with the

Win SPM application for information. If your system includes the Intuity or IS II/III

applications, you have the UNIX System version of SPM.

For information about accessing SPM from the IS II/III application, refer to the

following books:

■ Integrated Solution III System Manager’s Guide, order no. 555-601-010

■ Integrated Solution III Installation and Maintenance Guide, order

no. 555-601-011

■ Integrated Solution II System Manager’s Guide, order no. 555-600-726

■ Integrated Solution II Installation and Maintenance Guide, order

no. 555-600-720

System Requirements 2

To use SPM for system programming, you need the SPM diskette and an

approved PC with version 3.3 (or later) of MS-DOS



. At a minimum, your PC

should support and include the following items:

■ At least 640 kbytes of RAM

■ A floppy disk drive to accommodate the SPM disk (3.5-inch or 5.25-inch)

■ A monochrome or color monitor

■ A serial port that can use either a DB-9 or DB-25 connector

NOTE:

For a DB-9 connector, use a 9-pin to 25-pin adapter to attach the

25-pin connector of the RS-232 interface cable.

■ An RS-232 interface cable of appropriate length for your site connection(s)

Depending on how you connect the PC to the control unit, you also need the

following items:

■ Direct local connection, if the PC is within 50 ft. of the control unit:

— Either a 355AF modular adapter (if there is a male connector on the

interface cable) or a 355A modular adapter (if there is a female

connector on the interface cable)

— A four-pair modular cord (D8W)

Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

Other manuals for Lucent Technologies MERLIN LEGEND Release 6.1