MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
General Feature Use and Telephone Programming
Page D-3Telephone and Operator Features
D
Feature Codes 4
Feature codes are 1-, 2-, and 3-digit codes that activate features. A feature code
is used by first pressing the dedicated Feature button on MLX telephones,
pressing a programmed Feature button on analog multiline telephones, or dialing
#
on single-line telephones. Each of these methods sends a signal to the system
that a feature code is about to be dialed. When the code is dialed, the feature is
activated.
NOTE:NOTE:NOTE:
Queued Call Console (QCC) system operators cannot use feature codes.
The following features can be used only by dialing feature codes:
â– Pickup
■Forward/Follow Me—Cancel One
■Forward/Follow Me—Cancel All
â– Message Cancel
â– Personal Speed Dial
â– System Speed Dial
NOTE:NOTE:NOTE:
Pressing the Conf, Transfer, Speaker, or Feature button while activating a
feature cancels the process. Pressing any other button, such as the Mute,
HFAI, Message Status, DSS Page, More, Message, Clock, analog
multiline display keys, or analog multiline disconnect button does not cancel
the feature-activating process.
Telephone and Operator Features 4
Table D–1 lists the telephone and operator features that can be assigned to
telephones or consoles, either through centralized telephone programming or by
users from their telephones.
To Next Page
Loading...
Need help?
General
