Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-282Extensions
3
Table 3–6 provides the programming codes for assigning Ring and Voice buttons.
You can handle errors in data entry as follows:
■ If you enter a feature code incorrectly while programming, the display
shows the
3URJUDPPLQJ(UURU message and the red LED next to the
button flashes. If this happens, press the button again and repeat the
procedure.
■ If you make a mistake and program the wrong feature on a button, press
the button, select
'HOHWH (

on the PC), and press the button again
Table 3–6. Programming Codes for Assigning Buttons
Use On the Console On the PC
To assign SA or ICOM
Ring button
Dial
 Type
To assign SA or ICOM
Voice button
Dial , press button
being programmed
again, and dia
l 
7\SH , press
=
+
function key for button
being programmed
again, and type

To assign SA or ICOM
Originate Only Ring button
Dial Type
To assign SA or ICOM
Originate Only Voice
button
Dial , press button
being programmed
again, and dial

Type , press = +
function key for button
being programmed
again, and type

To assign SA button Dial , press the
extension number of
principal telephone
[nnnn] then press the
button number being
shared
[nn]
Type , press the
extension number of
principal telephone
[nnnn]
then press the
button number of
specific button being
shared
[nn]
To change current
assignment for SA or
ICOM Voice, Originate
Only or Shared SA buttons
from Voice to Ring
Dial Type

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English