MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming Basics
Page 1-20Programming Procedures
1
Saving Entries and Moving among Screens 1
At the bottom of each screen one or more screen keys may appear representing
functions that allow you to change your entry, save your entry, or return to a
previous screen. Various combinations of these screen keys appear on each
programming screen. Figure 1–10
shows the QCC Priority screen with a typical
display of screen keys.
Figure 1–10. Screen Keys
The PC keys that correspond to the screen key selections are shown here for
quick reference. These PC keys do not appear on the console display screen.
Table 1–4
contains details on the use of the screen keys.
Table 1–4. Screen Keys
4&&3ULRULW\
Y
x
= QCC Priority entered in earlier Step
(QWHUOLQHWUXQNQXPEHU
YYY
xxx
= line/trunk number (801–880)
'HOHWH
%DFNVSDFH 1H[W
([LW (QWHU
DisplayPC KeyFunction
%DFN6SDFH
or
>
Change your entry. Select
%DFNVSDFH (
or
>
on the PC) to correct your entry. Each time
you press the key, the screen cursor moves
backward to erase one character at a time.
(QWHU
or
1
Save your entry. Typically, you select
(QWHU (
or
1
on the PC) to complete a procedure and
save the information. Occasionally, you must select
([LW (
on the PC) and return to a previous
screen after you use (QWHU. If the entry is not valid,
the system may beep and/or display an error
message and does not save the entry.
'HOHWH
Delete a current entry. Select
'HOHWH (
on the
PC) to delete (or remove) a current entry.
Continued on next page
To Next Page
Loading...
Need help?
General
