Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming with SPM
Page 2-10Installing the SPM Software
2
NOTE:NOTE:NOTE:
The DEBUG
attribute is also specified in ams.cfg as '(%8* 2 (off), the
factory setting, or
'(%8*  (on). This attribute is used to enable the Escape-
to-Shell feature of SPM, activated by pressing
<
+

. To turn DEBUG
on,
you must edit the ams.cfg file; it is not part of the initialization process. The
DEBUG
attribute is for use by qualified service personnel only.
Table 2–1. SPM Configuration File (ams.cfg) Options
Follow the steps below to perform the SPM initialization.
! Type
TQN and press 1 to display the SPM Welcome screen shown in Step 2.
■ Make your entry at the &! prompt if you have installed SPM on your PC’s
hard disk.
■ Make your entry at the $! prompt if you are using the floppy drive.
! Press any key.
Option Use
TQN−DPN Specifies COM1 as the serial communications port
used by SPM
TQN −DPN Specifies COM2 as the serial communications port
used by SPM
TQN −T Specifies modem speed of 1,200 bps
TQN−T Specifies modem speed of 2,400 bps
TQN−DPMPS Specifies color monitor
TQN−NPOP Specifies monochrome monitor
TQN−FOHMJTI Specifies English as the PC language
TQN−GSFODI Specifies French as the PC language
TQN−TQBOJTI Specifies Spanish as the PC language
:HOFRPHWR630
X.XX = current version of SPM
7KH0(5/,1/(*(1'
6\VWHP3URJUDPPLQJ
0DLQWHQDQFH8WLOLW\
3OHDVHSUHVVDQ\NH\
WRFRQWLQXH
9HUVLRQ ;;;

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English