Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Centralized Telephone Programming
Page 4-4Program Extension
4
The sections that follow explain the use of menu selections for programming a
single extension (Program Extension), and for using one extension as a template
for programming several extensions of the same type (Copy Extension).
NOTE:NOTE:NOTE:
It is recommended that you use the programming codes for centralized
programming; however, you may also use the
/LVW)HDWXUHV option that is
available on the programming screen. See “Using the List Feature Menu”
on page 4–12 for details about this option.
Program Extension 4
Review the items below before you begin to program extensions.
■ Use Table 4–1 on page 4-7 to locate the code for the feature that you want
to program.
■ If you enter a feature code incorrectly or enter a feature code that is not
appropriate for the button, a beep sounds or the message
3URJUDPPLQJ
(UURU
appears and the green LED next to the button flashes. If this
happens, press the button again and repeat the procedure.
■ If you make a mistake and program the wrong feature on a button, follow
the steps below:
1. Press the button.
2. Select
'HOHWH (press  on the PC).
3. Press the button again.
■ If you press a line button that is not active, the screen shown here appears.
Press Home to return to the Home screen.
■ You can use the Extension Information (([W,QIR) report option on the
Print menu to print all of the programmed features for a specific extension.
At the Centralized Programming menu, follow the procedure below to program
features onto a single telephone.
%ODQN
3UHVV+20(WR([LW
3DJH
3DJH
6\V3URJUDP /LVW)HDWXUH

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English