MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-596Labeling
3
Labeling 3
The procedures in this section cover how to add or change labels for the following:
■ Extension Directory
■ Lines or Trunks
■ Posted Message
■ Group Calling
■ System Speed Dial Directory
Programming on the system programming console:
Use the buttons next to the display to specify the letters A through I and
punctuation. Use the line/feature buttons to specify additional alphanumeric
characters for labels. Use the template provided with the MLX-20L telephone to
see which line buttons correspond to which alphanumeric characters.
Programming with SPM:
Use the PC keyboard for labels. All letters appear on the screen in uppercase.
NOTE:NOTE:NOTE:
See the
MLX-20L User’s Guide
for instructions on creating or editing a
personal directory.
Extension Directory 3
Use this procedure to establish alphanumeric system labels for display telephone
users to identify the person calling or leaving a message. This procedure is also
used to program the Extension Directory feature for MLX telephones.
NOTE:NOTE:NOTE:
In Release 6.0 and later systems (Hybrid/PBX mode only) where private
networked systems are connected by PRI tandem trunks, programmed
labels for extensions on the remote system may be displayed at a call
recipient’s MLX display telephone on a local system. If other types of trunks
connect the private network systems, the call display is the same as for an
outside call. For additional information about controlling the display for such
incoming calls, see “Display Preference” on page 3–356
.
A label can have a maximum of seven characters.
To Next Page
Loading...
Need help?
General
