MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-547Automatic Route Selection
3
Console Display/Instructions Additional Information PC
! Enter the restriction level (
n
= 0 to 6).
! Continue to enter FRL for another pool route or go to Step 5.
Select
1H[W.
Return to Step 3. The next route is
displayed on Line 1.
! Save your entry.
Select
(QWHU.
! Return to the System Programming menu.
Select
([LW twice.
Digit Absorption 3
Use this procedure to specify how many of the digits dialed (0 through 11) by the
caller should be absorbed (not sent to the telephone company’s central office) by
the system when a call is made on an identified route.
Entries of 1 through 11 indicate that the system should not send the specified
number of digits, starting with the first digit dialed by the user after the dial-out
code.
Digit absorption is assigned to Tables 1 through 18.
NOTES:
1. Pool routes must be programmed before you assign digit absorption.
2. In Release 6.0 and later systems where remote users will dial out via
private network lines, absorbed digits are often useful. For example, if
remote callers are in the 908 area code but your system is in the 617
area code, callers might dial
, where is the remote ARS
access code. Because the call is a local call on the remote system, the
absorbed digits on that system would be
.
$567DEOH[[5RXWH[
xx
= table number entered in Step 1
(QWHUUHVWULFWLRQOHYHO
x
= route number entered in Step 1
%DFNVSDFH 1H[W
([LW (QWHU
Dial or type [
n
].
Ã
To Next Page
Loading...
Need help?
General
