Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming with SPM
Page 2-73Upgrading the System
2
Table 2–14. Programming Needed after Upgrade to Release 5.0
Table 2–13. Programming Needed after Upgrade to Release 4.2 (Continued)
Feature Sequence
PRI Call-by-Call
Services Table
To select MCI Toll Call-by-Call Services for a
DMS-250 or DEX600E switch type:
6\V3URJUDP→([LW→/LQHV7UXQNV→35,→
2XWJRLQJ7EO→&%&6HUYLFH→1HWZRUN6HUY→
List no.
→(QWHU→ 0&,7ROO→0&,35,60 or
0&, 91(7→(QWHU
To specify local exchange carrier Dial Plan Routing
services for a DMS-100 switch type:
6\V3URJUDP→([LW→/LQHV7UXQNV→35,→
2XWJRLQJ7EO→&%&6HUYLFH→1HWZRUN6HUY→
List no.→(QWHU→'06/RFDO→'063ULYDWH or
'06287:$76 or '06);RU'067LH7UN→(QWHU
Feature Sequence
CTI Link This is a Maintenance step. Start the procedure from
the main menu, not the System Programming screen.
Busy-out the board first:
Menu
→0DLQWHQDQFH→6ORW→Dial slot no.→
(QWHU→%XV\2XW→<HV
Program the CTI link (the switch must be in
Hybrid/PBX mode):
$X[(TXLS→&7,/LQN→Dial extension no.→(QWHU→
([LW→([LW
This is a Maintenance step. Start the procedure from
the main menu, not the System Programming screen.
Restore the slot:
Menu
→0DLQWHQDQFH→6ORW→Dial slot no.→ (QWHU→
5HVWRUH→<HV
NOTE:NOTE:NOTE:
If the MLX module containing the CTI link is the first module,
use the SPM program to busy-out the slot.
Continued on next page

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English