MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-492System Features
3
Interdigit Timers 3
Programming for interdigit timers is reserved for Lucent Technologies technical
support personnel or authorized dealers.
Interdigit timers are used by the MERLIN LEGEND system to determine when a
user originating an outside call has completed dialing the digits. The information is
necessary to allow the system to perform subsequent operations. You should not
change the factory settings for interdigit timers unless instructed to do so by
Lucent Technologies technical support or by an authorized dealer.
Allowed Lists 3
Use this procedure to establish Allowed Lists. These lists are telephone numbers
that can be dialed from specified telephones, regardless of any calling restrictions
assigned to the telephones.
A maximum of eight lists (numbered 0 through 7) with a maximum of 10 numbers
each (numbered 0 through 9) are allowed. Each allowed number can be no more
than six digits (an area code plus an exchange) or six digits with a leading 1,
where required.
If you program 0 as the first digit of a list entry, any toll restriction assigned to the
extension is removed for calls that can be placed by a toll operator.
Special characters (such as Pause) are not permitted in Allowed List entries.
Summary: Allowed Lists 3
Programmable by System Manager
Mode All
Idle Condition Not required
Planning Form Form 6g, Call Restriction Assignments and Lists
Factory Setting Not applicable
Valid Entries Area code/exchange (1- to 6-digits with leading 1, if
necessary)
Inspect No
Copy Option No
Console Procedure
7DEOHV→$OORZ/LVW→Dial list no. and entry no.→
(QWHU→Drop→Dial no.→(QWHU→([LW
PC Procedure

→→Type list no. and entry no.→→
7
+
I→Type no.→→
To Next Page
Loading...
Need help?
General
