MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming with SPM
Page 2-7Installing the SPM Software
2
Installation 2
With Windows 95 running on your PC, follow these steps to install SPM on the
PC’s hard disk:
! Insert the SPM installation disk in any floppy disk drive (usually the A drive).
! Choose
one
of the following two methods to install SPM:
Method 1 – Install DOS SPM with French, Spanish, or English Language: 2
1. Open a DOS Window from Windows Explorer.
2. At the DOS prompt, switch to the drive with the SPM installation disk
(usually the A drive).
3. At the DOS prompt, type one of the commands shown below and press
1
.
■JOTUBMorJOTUBMFOHMJTI
■JOTUBMGSFODI
■JOTUBMTQBOJTI
NOTE:
Because English is the factory-set language, JOTUBM and
JOTUBM FOHMJTI have the same result. If you do use the
language argument (
FOHMJTI, GSFODI, or TQBOJTI), you must
type it in lowercase letters as shown. The command
JOTUBM may be in uppercase or lowercase letters.
Method 2 – Install DOS SPM with French, Spanish, or English Language: 2
1. From the Windows Explorer, select the floppy drive that contains the
backup copy of the SPM disk.
2. Select and run ,QVWDO (either by double-clicking on the file name or
single-clicking on the file name and using the menu choice File:Open).
! After you start the DOS SPM installation using either method, the following
message appears:
630:,1'2:6+$5'',6.,167$//$7,21352*5$0
3UHVVDQ\NH\WRFRQWLQXH
! Press any key to begin the installation.
To Next Page
Loading...
Need help?
General
