Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
General Feature Use and Telephone Programming
Page D-12Telephone Programming
D
Telephone Programming 4
The following describes how to program features on MLX and analog multiline
telephones. Because Personal Speed Dial is the only feature that single-line
telephone users can program, general programming instructions for single-line
telephones are not provided.
NOTE:NOTE:NOTE:
Features cannot be programmed on QCCs in system operator positions.
Features assigned to these consoles are fixed and cannot be changed.
Programming Methods D
Telephones can be programmed by dialing programming codes or, on MLX
display telephones, by selecting features from the display. Analog multiline
telephones cannot be programmed by selecting features from the display.
To program a telephone, first enter programming mode:
■ On analog multiline telephones, slide the Test/Program (T/P) switch on the
side of the telephone to P, or lift the handset, or press Spkrphone and dial
#00.
■ On MLX-10 and MLX-5 nondisplay telephones, press the Feature button
and dial
00.
■ On MLX display telephones, use the same procedures as for the MLX
nondisplay telephones, or enter programming mode by selecting
([W
3URJUDP
from the menu screen on the display.
■ On MDC 9000 and MDW 9000 telephones, press the imprinted Feat button
and dial
00.
See the appropriate user or operator guide for more information.
NOTE:NOTE:NOTE:
Features can also be programmed onto individual telephones through
centralized telephone programming. The steps for using programming
codes vary, depending on the telephone. Tables D–2
through D–5 list the
basic steps for programming each telephone type.

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English