Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-20System Renumbering
3
System Renumbering 3
The procedures in this section are used to assign the 2-digit, 3-digit, and Set Up
Space numbering plans for the local MERLIN LEGEND Communications System.
NOTE:NOTE:NOTE:
System Renumbering is called
Flexible Numbering in the MERLIN II
Communications System. This is
not the same as Board Renumbering, an
option used when modules in the control unit are changed.
Do not attempt to assign a numbering plan without Planning Forms 2a, System
Numbering: Extension Jacks; 2b, System Numbering: Digital Adjuncts; and 2d,
System Numbering: Special Renumbers. Form 6a, Optional Operator Features, is
needed to assign a DSS Page button. This section contains the following
programming procedures:
■ Select System Numbering Plan
■ Single Renumbering
■ Block Renumbering
■ Non-Local Dial Plan Renumbering (Release 6.0 and later systems only)
■ Direct Station Selector (DSS) Page Button Assignment
For the local system, you then select only one of the numbering plans (2-digit
numbering, 3-digit numbering, or Set Up Space numbering). In addition, you may
need to perform single and/or block renumbering. You do not need to assign DSS
Page buttons unless the system programming console or one of the operator
positions is connected to a DSS. No matter which procedures you need to
perform, assign the numbering plan first, then do single and/or block renumbering,
and finally, assign DSS Page buttons (if necessary).
In Release 6.0 and later systems (Hybrid/PBX mode only), you may choose
non-local dial plan numbering to specify the numbering of extensions connected
to remote private network systems and to allow users on your system to access
those extensions as if they were connected to your own system. You specify only
ranges of extensions.
NOTE:NOTE:NOTE:
Refer to the
Network Reference for information on private networking and
non-local dial plan numbering.
Use the single renumbering procedure whenever the extension numbers you are
changing
from or to are not sequential.
Block renumbering is quicker, but you can use block renumbering only when the
extension numbers you are changing
from and to are sequential.

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English