Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-26System Renumbering
3
Single Renumbering 3
Use this procedure to assign a specified extension number to a telephone,
accessory, line, pool (Hybrid/PBX only), calling group, paging group, or Listed
Directory Number. Single renumbering is also used for Remote Access, Park, Idle
Line Access (Key and Behind Switch only), and Automatic Route Selection
(Hybrid/PBX only).
!
CAUTION:
!
CAUTION:
Select (YJU on the console, or  on the PC, after renumbering
extensions. If you press Home, extensions may remain in the forced idle
condition (indicated when the LED next to each DSS button is on). To
restore extensions to their normal operating state, restart the system.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
Summary: Single Renumbering 3
Programmable by System Manager
Mode All
Idle Condition System idle
Planning Form Form 2a, System Numbering: Extension Jacks
Form 2b, System Numbering: Digital Adjuncts
Form 2d, System Numbering: Special Renumbers
Factory Setting Not applicable
Valid Entries Old and new extension numbers
Inspect Yes
Copy Option No
Console Procedure
6\V5HQXPEHU→6LQJOH→Select item→Dial old ext. no.→
(QWHU→Dial new ext. no.→(QWHU→([LW→([LW
PC Procedure

→→Select item→Type old ext. no.→→
Type new ext. no.→→→

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English