Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming with SPM
Page 2-17Accessing SPM
2
Accessing SPM 2
The procedure for accessing SPM depends on whether your PC is connected to
the control unit with a modem (either local or remote) or without a modem (direct).
This section covers both of these access procedures.
With a Direct Local Connection 2
To access SPM when your PC is connected directly to the control unit, follow the
steps below.
! Set up the appropriate physical connections between the PC and the control
unit.
See “Connecting the PC” on page 13.
! If you installed SPM on the hard disk of the PC, go to Step 5.
! If SPM is not installed on the hard disk, insert the SPM disk into Drive A.
! Type
Band press
1
.
$! appears on the screen.
! Type
TQN and press
1
to display the SPM Welcome screen shown below.
! Press any key to display the SPM Main Menu shown below.
:HOFRPHWR630
X.XX current version of SPM
7KH0(5/,1/(*(1'
6\VWHP3URJUDPPLQJ
0DLQWHQDQFH8WLOLW\
3OHDVHSUHVVDQ\NH\
WRFRQWLQXH
9HUVLRQ ;;;
6300DLQ0HQX
0HQX6HOHFW)XQFWLRQ
 6\V3URJUDP 0DLQWHQDQFH


%DFNXS 5HVWRUH


%RDUGV 3DVV7KUX


3ULQW2SWV 3DVVZRUG


0RQLWRU /DQJXDJH


Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English