MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-528Automatic Route Selection
3
Automatic Route Selection 3
This section contains programming procedures for the following Automatic Route
Selection (ARS) features:
■ 1 + 7-Digit Dialing Requirements
■ ARS Tables
■ Start and Stop Times for Subpatterns
■ Pool Routing
■ Facility Restriction Level (FRL)
■ Digit Absorption
■ Other Digits
■ N11 Special Numbers Tables
■ Dial 0 Table
■ Voice and/or Data Routing
NOTE:NOTE:NOTE:
ARS applies to Hybrid/PBX mode only.
ARS over Private Networked Tandem PRI
and Tie Trunks 3
In Release 6.0 and later systems, Hybrid/PBX mode only, callers on one system
can use lines on another system quickly and transparently for optimal cost by
routing calls to a different switch in the organization’s private network (in prior
systems, it is necessary to make an explicit remote-access call, enter a barrier
code, and finally use ARS). To permit this operation, both the local and remote
systems must be programmed using ARS and remote access options.
Remote Users Calling out on Local Private
Networked Lines 3
To implement this operation on a local system where remote callers will use the
private networked lines connected to your system, use the procedures outlined in
the section “Remote Access Features” on page 3–502
.
To Next Page
Loading...
Need help?
General
