Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-562Automatic Route Selection
3
Voice and/or Data Routing 3
Use this procedure to route voice, data, or voice and data. The voice/data
specification is used mainly in conjunction with PRI. See “PRI Facilities” on page
3–183 especially its subtopic, “Outgoing Tables” on page 3–238.
Voice/data routes can be associated with Subpattern A or Subpattern B.
Summary: Voice and/or Data Routing 3
Programmable by System Manager
Mode Hybrid/PBX
Idle Condition Not required
Planning Form Form 3g, Automatic Route Selection Default and
Special Numbers Tables
Factory Setting Voice
Valid Entries Voice Only, Data Only, Voice/Data
Inspect No
Copy Option No
Console Procedure
7DEOHV→$56→More→6XE$'DWD or 6XE%'DWD→
Dial table no. and route no.→(QWHU→Select capability→
(QWHU→([LW→([LW
PC Procedure

→→→
or
→Type table no. and route
no.
→→Select capability→→→
Procedure: Voice and/or Data Routing 3
Console/Display Instructions Additional Information PC
! Select the Tables menu.
6\VWHP3URJUDPPLQJ!
0DNHDVHOHFWLRQ
6\VWHP ([WHQVLRQV
6\V5HQXPEHU 2SWLRQV
2SHUDWRU 7DEOHV
/LQHV7UXQNV $X[(TXLS
([LW 1LJKW6UYFH


Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English