MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming with SPM
Page 2-41Using SPM
2
Language 2
A language attribute in the SPM configuration file \spm\ams.cfg (DOS version) or
/usr/ams/ams.cfg (UNIX System version) specifies whether SPM menus, pop-up
windows, and other messages are presented in English, French, or Spanish. A
second language selection option affects messages from the control unit to SPM,
and controls the display on the console simulation window for the duration of the
session. These two language options operate independently of each other.
The following discussion refers to the language specified in the SPM configuration
file as the
PC language
and the language used by the control unit as the
console
window language.
PC Language 2
During SPM installation, you select a language that is recorded in the SPM
configuration file. Any time thereafter, SPM can be started with the
−M
option to
specify a different language, using one of the following command lines:
■ TQN−MFOHMJTI
■ TQN−MGSFODI
■ TQN−MTQBOJTI
Note that the option is a lowercase letter L and not the number 1.
Use of the
O option changes the language attribute in the ams.cfg file. The
language specified becomes the new PC language, used whenever SPM is
started without the
O option.
Console Window Language 2
By default, the language used in the console simulation window is the language
specified in the ams.cfg file; however, you can select a different language for this
window for the duration of the current session.
To select a different language for the current session, follow the steps below.
! At the SPM Main Menu, press
%
to select
/DQJXDJH.
6300DLQ0HQX
0HQX6HOHFW)XQFWLRQ
6\V3URJUDP 0DLQWHQDQFH
%DFNXS 5HVWRUH
%RDUGV 3DVV7KUX
3ULQW2SWV 3DVVZRUG
0RQLWRU /DQJXDJH
To Next Page
Loading...
Need help?
General
