Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming with SPM
Page 2-52System Programming
2
NOTE:NOTE:NOTE:
If a procedure requires an idle condition, perform the programming outside
of normal business hours.
If a procedure requires that the system be in an idle state and the system is busy
when you begin, you see the screen shown below.
The screen changes to the appropriate programming screen when the system is
no longer busy.
System Forced Idle 2
When the entire system is forced idle, no calls can be made or received. The
procedures listed below can be performed only when the entire system (every line
and every extension) is idle:
■ Select system mode
■ Identify system operator positions
■ Renumber boards
■ Renumber system
■ Identify telephones with voice signal pairs for the Voice Announce to Busy
feature
■ Identify telephones that need the Simultaneous Voice and Data feature
■ Restore system programming information
■ Identify the Music On Hold jack
When the system is forced idle, the following occurs: Multiline telephone users
hear a reminder tone that indicates the telephone cannot be used; display
telephone users see the message
:DLW6\VWHP%XV\; single-line telephone
users do not hear a dial tone.
6\VWHP%XV\3OV:DLW
'LDO&RGH OOOO
6ORW3RUW TTQQ
([LW

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English