Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-63Lines and Trunks
3
Console/Display Instructions Additional Information PC
! Select Loop-Start Disconnect.
! Specify the disconnect signal as reliable or unreliable.
! Save your entry.
! Return to the System Programming menu.
Select
([LW twice.

Toll Type 3
Use this procedure to specify whether users have to dial a toll prefix (1 or 0)
before dialing an area code and telephone number. (Your local telephone
company should verify toll prefix requirements for each line/trunk.)
This setting is used by the system to classify calls as local or long distance, so
that appropriate toll restrictions can be applied.
NOTE:NOTE:NOTE:
This option applies only to loop- and ground-start trunks; it does not apply
to tie trunks or DID trunks.
7RXFK7RQH/6'LVFRQQHFW
0DNHDVHOHFWLRQ
2XWPRGH
/6'LVFRQQHFW
([LW

/65HOLDEOH'LVFRQQHFW
6HOHFWRQH
<HV
1R
Select <HV or

([LW (QWHU
1R.

Select
(QWHU.


Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English