Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-73Lines and Trunks
3
Console/Display Instructions Additional Information PC
! Continue to assign a principal user to another line or trunk, or go to Step 9.
Select
1H[W.

Return to Step 6. The next line/trunk
is displayed on Line 1.
! Save your entry.
Select
(QWHU.

!Return to the System Programming menu.
Select
([LW twice.

QCC Queue Priority Level 3
Use this procedure to assign QCC queue priority level values (1 to 7) to each
loop-start, ground-start, and automatic-in tie trunk in your system. The value
assigned determines the order in which calls are sent to the QCC operator
positions. Call priority 1 is the highest priority, and 7 is the lowest priority.
NOTE:NOTE:NOTE:
This procedure applies to Hybrid/PBX mode only in a system that includes
QCC operator positions.
Summary: QCC Queue Priority Level 3
Programmable by System Manager
Mode Hybrid/PBX
Idle Condition Not required
Planning Form Form 2c, System Numbering: Line/Trunk Jacks
Factory Setting 4
Valid Entries 1 to 7
Inspect Yes
Copy Option No

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English