Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-80Lines and Trunks
3
Console/Display Instructions Additional Information PC
! Specify the line(s) associated with the QCC operator. ● ◆
● Single Line Procedure
Console/Display Instructions Additional Information PC
! Specify entry mode.
Select
(QWU\0RGH.

! Enter the line/trunk assigned to ring into the QCC queue.
! Assign or remove the line/trunk from the specified QCC operator.
Select
(QWHU or

'HOHWH.

You may continue to assign or remove additional
lines/trunks from the QCC operator by repeating
Steps 2 and 3.
! Continue to assign line/trunk to another QCC operator or go to Step 5.
Select
1H[W.

Return to Step 2. The next QCC operator
is displayed on Line 1.
! Return to the System Programming menu.
Select
([LW twice.

4&&2SHUDWRU YYYY 
xxxx = extension number entered in Step 4
(QWHUOLQHWUXQNQXPEHU
/LQHV (QWU\0RGH
For a single line/trunk, go to
/LQHV
● Single Line Procedure.
/LQHV
/LQHV
For a block of lines/trunks, go to
([LW
◆ Block Procedure.
4&&2SHUDWRU YYYY 
xxxx = extension number entered in
(QWHUOLQHWUXQNQXPEHU
Step 4
Dial or type:
Ã
'HOHWH
Trunk number [ nnn ]
%DFNVSDFH 1H[W
Slot and port number [ sspp ]
([LW (QWHU
Logical ID number #[ nnn ]

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English