EasyManuals Logo

Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

Lucent Technologies MERLIN LEGEND Release 6.1
1010 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #279 background imageLoading...
Page #279 background image
MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-101Uniform Dial Plan Facilities
3
Wherever possible, the same switch identifiers should be used for the same
switch across a private network. For example, LEGEND A is identified by switch
identifier 22 in LEGEND B and LEGEND C systems in a private network. This
helps avoid a situation where calls are directed in a loop through several systems.
However, a trunk may connect to a switch that is a satellite for one networked
system but not a satellite for another networked system. In this case, a system
may have more than one switch identifier. For example, LEGEND D may be
located within 200 miles of LEGEND E but be more than 200 miles from
LEGEND F in the same private network. In this case, the switch identifier for
LEGEND D (for example, 21) in LEGEND E is different from the identifier for
LEGEND D (for example, 1) as specified in LEGEND F.
This topic includes procedures for adding a switch identifier to a single trunk or to
a block of sequentially numbered trunks.
Summary: Switch Identifiers 3
Programmable by System Manager
Mode Hybrid/PBX
Idle Condition Not required
Planning Form Form 2c, System Numbering: Line/Trunk Jacks
Form 3b, Incoming Trunks: DS1 Connectivity (100D Module)
Factory Setting Null (no value)
Valid Entries Null, 1–20, 21–40, 41–50, 51–60
Inspect No
Copy Option No
Console Procedure To enter or remove an identifier for one trunk:
/LQHV7UXQNVMore8'36Z1XP6LQJOH
Dial trunk no.(QWHUDial switch no.(QWHU or 'HOHWH
([LW([LW([LW
To enter or remove identifiers for a block of trunks:
/LQHV7UXQNVMore8'36Z1XP%ORFNDial starting
trunk in block
(QWHUDial ending trunk in block
(QWHUDial switch no.(QWHU or 'HOHWH
([LW([LW([LW
PC Procedure To enter or remove an identifier for one trunk:
Type trunk no.
Type switch no.
or
To enter or remove identifiers for a block of trunks:
Type starting trunk in block
Type ending trunk in blockType switch no.
or

Table of Contents

Other manuals for Lucent Technologies MERLIN LEGEND Release 6.1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent Technologies MERLIN LEGEND Release 6.1 and is the answer not in the manual?

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General IconGeneral
BrandLucent Technologies
ModelMERLIN LEGEND Release 6.1
CategoryConference System
LanguageEnglish

Related product manuals