Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-147Tie Trunks
3
Console/Display Instructions Additional Information PC
! Save your entry.
Select
(QWHU.

! Specify the type of signaling for the trunk.
! Continue to assign E&M signaling to another trunk, or go to Step 8.
Select
1H[W.

Return to Step 6. The next trunk is
displayed on Line 1.
! Save your entry.
Select
(QWHU.

! Return to the System Programming menu.
Select
([LW twice.

Dial Mode 3
Use this procedure to specify whether an incoming or outgoing tie trunk is touch-
tone or rotary.
Touch-tone cannot be programmed for incoming immediate signaling tie trunks.
Users of touch-tone single-line telephones cannot make calls by using individual
trunks programmed for rotary operation. The touch-tone signals generated from
the telephone while the user is dialing are transmitted to the central office at the
same time the rotary signals are sent to the system. The central office receives
both signals and cannot process the call.
7UXQN YYY 
xxx = trunk entered in Step 4
6HOHFW(07UN6LJQDOLQJ
7\SH6
7\SH&
7\SH
Select 7\SH6,

1H[W
7\SH&, or

([LW (QWHU
7\SH.


Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English