Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-178DID Trunks
3
Console Display/Instructions Additional Information PC
! Erase the current number of added digits (
nnn ).
! Enter the number of digits to add (
n = 1 to 9999).
Dial or type [
n ]. Ã
! Continue to specify added digits for the other trunk block or go to Step 9.
Select
1H[W.

Return to Step 6. The next block is
displayed on Line 1.
! Save your entry.
Select
(QWHU.

!Return to the System Programming menu.
Select
([LW twice.

Signaling 3
Use this procedure to specify whether the type of dialing signal from the local
telephone company is touch-tone or rotary. Touch-tone dial mode cannot be
programmed for immediate-start DID trunks.
Touch-tone single-line telephone users cannot make calls by using individual
trunks programmed for rotary operation. The touch-tone signals generated from
the telephone while dialing are transmitted to the central office at the same time
the rotary signals are sent to the system. The central office receives both signals
and cannot process the call.
','%ORFN Y 
x = block entered in Step 4
(QWHUGLJLWVWRDGG
OOO
%DFNVSDFH 1H[W
([LW (QWHU
Press Drop.
7/I

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English