Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-213PRI Facilities
3
Test Telephone Number 3
Use this procedure to assign a test line or trunk telephone number for each 100D
module installed in the control unit.
The number assigned to the test line/trunk must be different from the numbers
assigned to other channels in the same B-channel group. It must be identical to
the number provided by the PRI service provider.
Summary: Test Telephone Number 3
Programmable by System Manager
Mode Hybrid/PBX, Key
Idle Condition Not required
Planning Form Form 3b, Incoming Trunks: DS1 Connectivity (100D module)
Factory Setting Not applicable
Valid Entries Telephone number of up to 12 digits
Inspect No
Copy Option No
Console Procedure
/LQHV7UXQNV→35,→7HVW7HO1XP→Dial slot no.→
(QWHU→Drop→Dial telephone no.→(QWHU→([LW→([LW
PC Procedure

→→→Type slot no.→→7
+
I→
Type telephone no.→ →→
Procedure: Test Telephone Number 3
Console Display/Instructions Additional Information PC
! Select the Lines and Trunks menu.
6\VWHP3URJUDPPLQJ!
0DNHDVHOHFWLRQ
6\VWHP ([WHQVLRQV
6\V5HQXPEHU 2SWLRQV
2SHUDWRU 7DEOHV
/LQHV7UXQNV $X[(TXLS
([LW 1LJKW6UYFH


Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English