Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-221PRI Facilities
3
Terminal Equipment Identifier 3
Use this procedure to assign the link layer address of a piece of equipment
connected to each D-channel. Normally, only one piece is connected and the
system assumes that the Terminal Equipment Identifier (TEI) is 0.
!
CAUTION:
!
CAUTION:
The value of the TEI rarely has to be changed. Check with your Lucent
Technologies representative before changing this value.
Summary: Terminal Equipment Identifier 3
Programmable by System Manager
Mode All
Idle Condition Not required
Planning Form Form 3b, Incoming Trunks: DS1 Connectivity (100D module)
Factory Setting 0
Valid Entries 0 to 63
Inspect No
Copy Option No
Console Procedure
/LQHV7UXQNV→35,→3URWRFRO→7(,→Dial slot no.→
(QWHU→Drop→Dial new ID no.→(QWHU→([LW→
([LW→([LW
PC Procedure

→→→→Type slot no.→→7
+
I→
Type new ID no.→→→→
Procedure: Terminal Equipment Identifier 3
Console Display/Instructions Additional Information PC
! Select the Lines and Trunks menu.
6\VWHP3URJUDPPLQJ!
0DNHDVHOHFWLRQ
6\VWHP ([WHQVLRQV
6\V5HQXPEHU 2SWLRQV
2SHUDWRU 7DEOHV
/LQHV7UXQNV $X[(TXLS
([LW 1LJKW6UYFH


Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English