Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-358Optional Extension Features
3
Console/Display Instructions Additional Information PC
! Save your entry.
Select
(QWHU or

1H[W

If you select
1H[W to assign a display preference
to the next extension in a sequence, repeat
Step 5.
! Return to the System Programming menu.
Select
([LW twice.

Service Observing 3
In Release 6.1 and later systems, use this procedure to configure up to 16 Service
Observing groups on a system. Each Service Observing group consists of one
Service Observer and a list of the stations (up to the system maximum of 200) that
the observer is allowed to monitor. A warning tone is programmed on a per group
basis to provide an audible indication that a station is being observed.
NOTE:NOTE:NOTE:
Service Observing may be subject to federal, state, or local laws, rules, or
regulations or require the consent of one or both of the call parties. You
must check in your jurisdiction and comply with all applicable laws, rules,
and regulations before using this feature. Failure to comply may result in
severe penalties.
Summary: Service Observing 3
Programmable by System Manager
Mode All
Idle Condition Not required
Planning Form Form 4d, MLX Telephone
Form 5b, Direct-Line Console (DLC): Digital
Form 11, Service Observing: Group Assignment
Factory Setting Warning: Yes
Valid Entries Warning: Yes, No
Inspect Yes
Copy Option No

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English