Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-395QCC Optional Features
3
Console Display/Instructions Additional Information PC
! Specify the calling group to provide QCC operator backup.
! Assign or remove the group as QCC operator backup.
Select
(QWHU or

'HOHWH.

You may continue to assign or remove calling
groups as QCC operator backups by repeating
Steps 2 and 3.
! Return to the System Programming menu.
Select
([LW two times.

Voice Announce 3
Use this procedure to enable or disable Voice Announce for the QCC. Voice
Announce is available only on a QCC in Release 4.0 and later.
When Voice Announce is enabled, every QCC in the system has one Voice
Announce Call button, the Call 5 (Ring/Voice) button. All Intercom calls that
originate from a QCC Call 5 (Ring/Voice) button are delivered as Voice Announce
calls.
When Voice Announce is disabled, all Intercom calls originating at the QCC Call
buttons are Intercom Ringing calls.
Summary: Voice Announce 3
Programmable by System Manager
Mode Hybrid/PBX
Idle Condition Not required
Planning Form Form 6a, Optional Operator Features
Factory Setting Disabled
Valid Entries Disabled, Enabled
Inspect No
4&&2SHUDWRU%DFNXS
(QWHU4&&RSHUDWRU
RI&DOOLQJ*URXS
'HOHWH
%DFNVSDFH
([LW (QWHU
SP: “Entering an Extension”
Ã

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English